unknown part on vv 4-3

mikem · Post by **mikem** » Tue Dec 16, 2014 9:18 am

wife and I purchased phonograph as we like old décor. on top right corner is hole where needle cup goes then just below is a smaller black square little cup with 2 flexible prongs sticking out 1 side. what is it for? ( the crank stem seems too thick to be slid under the prongs ) thank you , mike.... plus and ideas where to get cheap needle cup ( 1 ½ inch wide circle plus about ½ inch deep) or something else to improvise as our needle cup missing.

Post by **gramophone78** » Tue Dec 16, 2014 9:23 am

mikem wrote:wife and I purchased phonograph as we like old décor. on top right corner is hole where needle cup goes then just below is a smaller black square little cup with 2 flexible prongs sticking out 1 side. what is it for? ( the crank stem seems too thick to be slid under the prongs ) thank you , mike.... plus and ideas where to get cheap needle cup ( 1 ½ inch wide circle plus about ½ inch deep) or something else to improvise as our needle cup missing.

Your two prong holder is for a tungs-tone needle tin. I would not recommend using it though. The prongs will scratch the tins face and therefore ruin it. You are welcome to place a wanted ad in our Yankee Trader section for your missing needle cup. Should be very easy to get.

: 20036.1L.png (425.26 KiB) Viewed 1273 times

mikem · Post by **mikem** » Tue Dec 16, 2014 9:14 pm

thank you very much for your feedback ! mike

Post by **gramophone78** » Tue Dec 16, 2014 9:47 pm

mikem wrote:thank you very much for your feedback ! mike

My pleasure. If you have any other questions or..???, feel free to ask on here. One of us will be sure to help...

.
Enjoy your new machine.

unknown part on vv 4-3

unknown part on vv 4-3

Re: unknown part on vv 4-3

Re: unknown part on vv 4-3

Re: unknown part on vv 4-3