WANTED: Nickel Victor Crank Escutcheon (will pay $65 each!)

Zwebie · Post by **Zwebie** » Fri Jan 23, 2015 12:47 pm

I am looking for an original, c. 1902 -1910 Victor crank escutcheon, see image below. Overall dimension is 1.42" x 1", hole spacing is 1.06". The bushing is nickel-plated brass.

Condition should be very good to excellent with intact nickel plating. The inside of the brass bushing may be only little worn. Usual staining and light rust film is ok, but it should be without pitting or corrosion. If not already done, please don't clean it, I polish the escutcheon myself. Please send me an image - front and back.

I will pay $65.00 each for two of these in excellent shape!

Thank You, Bob S.

Zwebie · Post by **Zwebie** » Sat Jan 24, 2015 8:56 pm

Zwebie · Post by **Zwebie** » Wed Jan 28, 2015 9:35 pm

Starkton · Post by **Starkton** » Sat Jan 31, 2015 4:42 am

Obviously, you utilized a photo of a nice escutcheon from my collection. I used it to get another good one on this website, but without success.

Zwebie · Post by **Zwebie** » Sat Jan 31, 2015 1:54 pm

Obviously, you utilized a photo of a nice escutcheon from my collection. I used it to get another good one on this website, but without success.

Yes Starkton, I used your picture, I beleive I also used most of your description. Sounds like you didn't have any luck finding an escutcheon either. Guess I'll have to raise my offer to $65.00 each.

WANTED: Nickel Victor Crank Escutcheon (will pay $65 each!)

WANTED: Nickel Victor Crank Escutcheon (will pay $65 each!)

Re: WANTED: Nickel Victor Crank Escutcheon

Re: WANTED: Nickel Victor Crank Escutcheon

Re: WANTED: Nickel Victor Crank Escutcheon (will pay $50 eac

Re: WANTED: Nickel Victor Crank Escutcheon (will pay $50 eac