FOR SALE: Victrola Credenza Parts - INQUIRE

[thatonejohn]

Selling this cabinet. More pictures are on the original post, http://forum.talkingmachine.info/viewto ... 08#p124108

I've had inquires on individual parts, but I am going to wait until Friday 3/20 before parting it out, just in case somebody wants to buy the entire thing (easier on my end). Located in Rapid City (57701), but I am willing to deliver or meet halfway along a convenient path. Denver is 400 miles or 6 hours, and is about my limit for one way of driving for delivering. Otherwise, it could be an excuse to go visit my parents in Minneapolis, so convenient places that don't add a huge amount of time to that trip would be Sioux Falls SD, Omaha NE, Des Moines IA, Bismarck ND, Fargo ND, Glendive MT, and pretty much anyplace in between those.

Let me know if you're interested in the entire thing, otherwise, parts will be divvied up on Friday. The person with the easiest/highest/most solid offer for a part by then will get priority on that part (Send me PMs with your interest). Afterwards, first come, first serve.

[thatonejohn]

Parts are up for grabs, just send me a message with what you want and how much you think is fair for it.

I'll update/edit this post when parts have been sold or when I've taken it off the market.

Sold Parts:
Metal vents on rear panels
Center Left side door minus hardware (left as in if you're looking at it from the front)

Available Parts:
8 Hinges and 47 screws for the hinges
4 Door pulls
3 remaining doors
Lid - veneer is lifting up at the rear right corner, some dings, but not terrible
Lid hardware
Lid piston supports that most likely need rebuilding as they didn't do much dampening
2 door stops (90 degree bent piece of metal that screws in on the underside of the top trim band)
2 middle side shelves, for 10" records
2 lower side shelves, for 12" records

[phonocookie]

Hi. Do you still have the lid?

[thatonejohn]

Hi. Do you still have the lid?

Yes, the lid is still available.

[Sartana]

PM sent. Thanks!