This gear is very poor and turns very noisy.
Does anybody have this for sell ?
WANTED: Victor gear
- kropton
- Victor I
- Posts: 131
- Joined: Wed Jul 06, 2011 6:29 am
- Location: Poland - Warsaw
- Contact:
-
- Victor IV
- Posts: 1387
- Joined: Mon Apr 26, 2010 3:13 pm
Re: WTB Victor gear
I don't know if the gear has ever been reproduced. It is a common issue on the Victor motors. The brass spindle gear wears a little over time and the edges of the teeth get small burrs or flatten out a bit. The edges become slightly "pie-shaped" instead of parallel. I use a small file to clean up the teeth and have had good success making motors play quietly. Place a dot with a marker to indicate where you start and 'dress' each tooth, a little at a time.
Adjusting the lateral movement on the governor is important as well so there is good alignment with the spindle gear. Of course, sometimes it just doesn't work and I have to rob a spindle gear from a parts motor and hope it will be better than the damaged one.
With a little tinkering these motors can usually be made quieter. good luck-
Brad Abell
Adjusting the lateral movement on the governor is important as well so there is good alignment with the spindle gear. Of course, sometimes it just doesn't work and I have to rob a spindle gear from a parts motor and hope it will be better than the damaged one.
With a little tinkering these motors can usually be made quieter. good luck-
Brad Abell
- kropton
- Victor I
- Posts: 131
- Joined: Wed Jul 06, 2011 6:29 am
- Location: Poland - Warsaw
- Contact:
Re: WTB Victor gear
thanks outune i will try it, but some teeth is really damaged.
so i looking for it to buy in better condition.
so i looking for it to buy in better condition.
-
- Victor II
- Posts: 207
- Joined: Wed Feb 15, 2012 7:27 pm
- Location: Long Island, NY
Re: WANTED: Victor gear
Ron Sitko has replacements.
- kropton
- Victor I
- Posts: 131
- Joined: Wed Jul 06, 2011 6:29 am
- Location: Poland - Warsaw
- Contact:
Re: WANTED: Victor gear
could you give me email / website to Ron Sitko ?
-
- Victor II
- Posts: 207
- Joined: Wed Feb 15, 2012 7:27 pm
- Location: Long Island, NY
Re: WANTED: Victor gear
He is not on the computer. Here is his info.
Ron Sitko
(518) 371-8549
56 Church Hill Road
Waterford, New York 12188
Ron Sitko
(518) 371-8549
56 Church Hill Road
Waterford, New York 12188
-
- Victor IV
- Posts: 1302
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
Re: WANTED: Victor gear
Can you post a better picture of the motor? I may be able to help you out, but I can't identify the motor from that picture. If this is a floor model Victrola, I probably have it.
Dave D
Dave D