WANTED: Cylinder Cabinet Drawer Pulls

ChuckA · Post by **ChuckA** » Mon Sep 21, 2015 9:22 am

I'm looking for a set of 5 drawer pulls for a cabinet I recently bought. Someone replaced the original brass with cheap wood knobs.

What the originals look like:

They are single hole mount.

Chuck

Post by **rgordon939** » Mon Sep 21, 2015 10:00 am

They look like H&S drawer pulls, very hard to find.

Rich Gordon

ChuckA · Post by **ChuckA** » Mon Sep 21, 2015 5:11 pm

rgordon939 wrote:They look like H&S drawer pulls, very hard to find.

Rich Gordon

Rich,

Of course they have to be hard to find, everything I go after at an auction or look for is either almost impossible to find or one of the most expensive pieces in the auction.

Chuck

edisonrestorer64 · Post by **edisonrestorer64** » Wed Sep 23, 2015 1:33 pm

this is so true I need Three side that are mounted for the drawer sliders and the draws also
really tough to locate.

Post by **emerson** » Wed Sep 23, 2015 1:52 pm

Chuck, Do you have any to make a copy from? Always good seeing you at the show--where was the big guy, didn't see him?

ChuckA · Post by **ChuckA** » Wed Sep 23, 2015 4:22 pm

emerson wrote:Chuck, Do you have any to make a copy from? Always good seeing you at the show--where was the big guy, didn't see him?

Yes I have some originals, but usually the cost to have new castings made is way above what I could buy another cabinet for. If I can't find them, I'll use some new ones that look better than the doorknobs that are on it now.

Good seeing you also, Les is slowing down a little and decided not to make the trip this time maybe the spring show.

Chuck

WANTED: Cylinder Cabinet Drawer Pulls

WANTED: Cylinder Cabinet Drawer Pulls

Re: WTB: Cylinder Cabinet Drawer Pulls

Re: WTB: Cylinder Cabinet Drawer Pulls

Re: WTB: Cylinder Cabinet Drawer Pulls

Re: WTB: Cylinder Cabinet Drawer Pulls

Re: WTB: Cylinder Cabinet Drawer Pulls