WANTED: Motor Parts for Victor D Motor (Bevel Drive 3 Spring

[Zeppy]

The situation is I am piecing together a late Victor D. I have a 3 spring bevel drive motor, however, it is from what I believe was a Victor MS, or similar European machine, meaning it had a 10 turntable, thus the speed control was closer in, and it also is treaded at the spindle for a record hold down.

So I am looking for parts to swap out for the bar that goes between the speed control and the governor, and the shaft that tops out at the spindle (one that would not be threaded). Attached are a few pictures of the motor.

Any leads would be helpful.

Thanks

[Phonofreak]

This motor could be an HMV/ G & T one. The threaded turntable spindle is on top. It looks like part where the turntable goes is also threaded. The turntable is threaded, too. That is common on early HMV/G & T machines.
Harvey Kravitz