WANTED: Corners for Victor III

[Wes K]

I am in need of two corners for a Victor III. I need two center parts and one top.

Thanks
Wes

IMG_0667.JPG[/attachment [attachment=1]IMG_0666.JPG

[Crank_it_up]

I'm pretty sure that George Vollema has these parts at Great Lakes Antique Phonographs. His contact info is in the "Links" section on this forum
Good Luck!
Joe

[alang]

George Vollema makes really nice replacements: http://www.victroladoctor.com/cabinet-parts/

Andreas

[Jerry B.]

Does your ID tag say III? It looks like a Victor M to me. Jerry

[JerryVan]

Does your ID tag say III? It looks like a Victor M to me. Jerry

Me too.

[Wes K]

Yes it is an M.

I would like to find some originals before I go the the reproduction route.

[Jerry B.]

If the machine were mine I would tap off enough parts to complete the columns in the front and use replacements, whether original or reproduction, at the back. Even original replacements will probably be a little off in finish due to different environmental conditions over the years. Good luck with your project.

Jerry Blais

[Phonolair]

Direct email sent

Larry Crandell