Help!....ID this horn

[Vinrage_mania]

I picked up a few horns ....with the dreded ictrola XO parts and want to try and figure out what it is for .The small end is 1 ½ and the bell is 8 inches the adapter goes down to ⅞ inch any ideas?? Thanks !

[Roaring20s]

Could it be for this?
http://forum.talkingmachine.info/viewto ... =9&t=35180

James.

[Ripduf1]

Hi, Please post a picture of a side view to be sure.

But to my eye it appears to be a common Columbia black horn. The brass end is different and I cannot ID it except that it appears to have the Columbia set screw on it, so it maybe a common horn with a not often seen adapter for a phono rather than a disk machine (Columbia Elbow). I will leave that to the Columbia collectors to hash out.

Please post a side view picture and length with out the brass bit. That will help ID it correctly.

John

[Vinrage_mania]

Length is 13.75 ish....with out the adaptor witch has very small barbs on the inside

[Phonofreak]

This appears to be the all black Columbia horn. If the length is 14" with an 8" diameter bell, then it is definitely a Columbia one. The brass fitting is probably an aftermarket adapter for use as a cylinder horn.
Harvey Kravitz

[ehs004]

Vinrage_mania,
If James is right about the adapter i would be interested!
Thanks Eric