WANTED: Crank for a Vic I

Thorhallur · Post by **Thorhallur** » Wed Aug 07, 2019 12:57 pm

Need a ¼" female crank with indirect wind

Jerry B. · Post by **Jerry B.** » Wed Aug 07, 2019 5:59 pm

I think you'd be really pleased with a Ron Sitko replacement for around $35. If, and it a big if, you found an original it will be at least twice that amount.

Jerry B.

Thorhallur · Post by **Thorhallur** » Wed Aug 07, 2019 6:27 pm

Jerry B. wrote:I think you'd be really pleased with a Ron Sitko replacement for around $35. If, and it a big if, you found an original it will be at least twice that amount.

Jerry B.

How do I contact him?

Retrograde · Post by **Retrograde** » Wed Aug 07, 2019 7:11 pm

Click HERE for Ron's contact info. Phone only.

Thorhallur · Post by **Thorhallur** » Wed Aug 07, 2019 7:38 pm

Retrograde wrote:Click HERE for Ron's contact info. Phone only.

Thanks!

jboger · Post by **jboger** » Sat Aug 10, 2019 2:01 pm

I may have what you are looking for. Pictured are two Victor cranks. They have the same threads and both screw easily into a VV-4, a late Vic I, and a Vic III. I am however uncertain that these are the right length for your machine. Here are the dimensions: The top one is about 3.5 inches from the threaded end to the bend, then another 3.5 inches to the handle. The one on the bottom is a little under four inches from the threaded end to the "bend", then another 3.5 inches to the handle.

My hope is that someone on this Forum can vouch for one of these to be what you need. Or not.

John

jboger · Post by **jboger** » Sun Aug 11, 2019 9:43 am

First I must apologize. Only the bottom crank in my previous post is available. The top one I intend to keep. I have a box of extra cranks in the garage; this one unfortunately was in it. Actually it belongs to a Vic III project that I have. Sorry for my mistake; it was unintentional, but only the bottom crank is available.

Thorhallur · Post by **Thorhallur** » Sun Aug 11, 2019 7:24 pm

jboger wrote:First I must apologize. Only the bottom crank in my previous post is available. The top one I intend to keep. I have a box of extra cranks in the garage; this one unfortunately was in it. Actually it belongs to a Vic III project that I have. Sorry for my mistake; it was unintentional, but only the bottom crank is available.

No worries! I have actually found an identical crank and have just bought it. Thanks so much for your reply and good luck with your Vic III project!

WANTED: Crank for a Vic I

WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I

Re: WANTED: Crank for a Vic I