Anyone know anybody who does "Stamped" brass parts?!??

[NEFaurora]

Subject:

Anyone know anybody who does "Stamped" brass parts?!??

Looking for someone to do a small run of small flat brass "stamped" parts. Maybe a 50 piece run to start.

If anyone has anyone in mind, Please post. The part will be absolutely flat and very simple to stamp.


Thanks,

)

Tony K.

Edison Collector/Restorer

[Django]

If a die is required, a 50 piece run will be very expensive per part. Not knowing the shape or tolerances, I cannot be sure what your needs are, but a better option for a short run might be laser or water jet.

[recordmaker]

The modern way to do this is by water jet cutting and this is great for these sorts of numbers as there is no physical tooling and only programing costs.

[fran604g]

My favorite local outfit. They ship all over the country.
https://smidgensinc.com/

[JerryVan]

Subject:

Anyone know anybody who does "Stamped" brass parts?!??

Looking for someone to do a small run of small flat brass "stamped" parts. Maybe a 50 piece run to start.

If anyone has anyone in mind, Please post. The part will be absolutely flat and very simple to stamp.


Thanks,

)

Tony K.

Edison Collector/Restorer

Just exactly what do you mean by a "stamped" part??? Is there a shape or form to stamped into a piece of brass? Or, do you mean stamped, as in stamped letters or numbers? It would be best if you simply showed the part you're trying to have made.

[Phonofreak]

What type of part do you need? If it is something simple, you might be able to scratch build one. I have done that many times from what I learned with model building.
Harvey Kravitz

[emerson]

I had worked at a stamping company (Stampings Inc. Mountainside, NJ), that did small run pieces----we did not make any parts for the company, only parts for other companies. We were sold out to a company and everything was moved to Rome, Georgia. I have no idea if they are still a working stamping house or not. There are still a few around here ---- Petersons, in Kenilworth, NJ. You can always try one for an estimate. Good Luck

[NEFaurora]

The part is actually a Flat "Key" for a certain type of display case....and it is flat...absolutely no raised areas.

)

Tony K.

[JerryVan]

You want to check out a wire EDM company, or water jet cutting, or laser cutting. A laser cutting company would probably be best.