WANTED: I need the Edison screws that are pictured here...

[NEFaurora]

WANTED: I need the Edison screws that are pictured here...

I need these for a customer repair... Anyone got any??? See pic Below. They are the 4 screws that are pictured in the foreground.

They hold the Edison Standard A (newer model A)/B Gear assembly to the Bedplate...

Will take buy up to 1 to 6 screws.....will take whatever you have.

They are common, but I don't have any....

Shoot me an e-mail at: [email protected] or PM me here.... Paypal money waiting...lol..

Much Thanks guys..

Tony K.

)


Edison Collector/Restorer

[studebakerphonos]

I think I have some new ones, they are cad plated I think, will that work?

Give me a day or so to check.

Best, Bob

[NEFaurora]

Looking for a few originals here on this project, but will keep you in mind...

These are relatively common, I just don't have any...lol...(ran out)

)

Tony K.

Edison Collector/Restorer

[Curt A]

I think I have some new ones, they are cad plated I think, will that work?

Give me a day or so to check.

Best, Bob

Just heat the cad plated screws with a torch to red hot and drop them in motor oil...

[startgroove]

You could go to your local hardware store, buy the right style screws there, in either brass or steel, even cadmium plated ones will work. Then get some Novacan (comes in dark brown or black) from your local stained glass store, or from Ebay, and dilute it about 50%, then soak them in the mixture until the right color is achieved, likely a few minutes. Once they dry, coat them in Watco oil and wipe off the excess. Let the oil dry for a few weeks, or bake them in an oven at 200 degrees for 20 minutes or more, before installing.

[studebakerphonos]

Brass might wear. Here's what I got.....

[NEFaurora]

Found what I needed... Got some originals. Much Thanks Kevin...

)

Tony K.

Edison Collector/Restorer