WANTED: Limit Screw for Brass Orthophonic Reproducer & Info

Buy, sell, or trade your phonograph-related items here [except music]
Forum rules
Post Reply
JerryVan
Victor Monarch Special
Posts: 6748
Joined: Mon Aug 24, 2009 3:08 pm
Location: Southeast MI

WANTED: Limit Screw for Brass Orthophonic Reproducer & Info

Post by JerryVan »

Could use 2 of the tiny limit screws & nuts that prevent over-travel of the needle bar. I need the ones for the brass Orthophonic reproducers only, (the ones used on the pot metal versions are larger).

Would also like to know the thread size of these screws.

Thanks!
Top
phonojim
Victor IV
Posts: 1478
Joined: Wed May 20, 2009 8:20 pm
Location: Mid - Michigan

Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I

Post by phonojim »

I'll try to check my stock of Ortho parts tomorrow. I think I have some but I'm not sure.

Jim
Top
JerryVan
Victor Monarch Special
Posts: 6748
Joined: Mon Aug 24, 2009 3:08 pm
Location: Southeast MI

Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I

Post by JerryVan »

phonojim wrote:I'll try to check my stock of Ortho parts tomorrow. I think I have some but I'm not sure.

Jim

Thanks Jim!
Top
phonojim
Victor IV
Posts: 1478
Joined: Wed May 20, 2009 8:20 pm
Location: Mid - Michigan

Re: WANTED: Limit Screw for Brass Orthophonic Reproducer & I

Post by phonojim »

I have one. Check your PMs.

Jim
Top
Post Reply

Return to “Yankee Trader”