FOUND: Double Cut Spindle Gear for VIC III Motor

CDBPDX · Post by **CDBPDX** » Thu Sep 03, 2020 8:11 pm

Anybody got a spare spindle gear (the one that engages the governor) for a VIC III motor? Double cut gear.

Thanks! Cliff

CDBPDX · Post by **CDBPDX** » Wed Sep 23, 2020 10:22 pm

Bump

Still looking...

Zwebie · Post by **Zwebie** » Thu Sep 24, 2020 9:34 am

P.M. Sent

Bob S.

Post by **Inigo** » Tue Sep 29, 2020 4:01 pm

I'm at the verge of changing my governor on an hmv junior tabletop, the small one spring motor with sloped governor, also double cut. The replacement I've acquired (same motor, newer style) is of the fine worm type, and I also have the matching spindle gear. If my replacements fit in my motor and work, so I can discard the old ones, my double cut spindle gear is yours to try. I could send it as postal letter / small package at a low cost (I'm in Spain). Will report as soon as I've tried the new parts, if you're still missing yours. Maybe it's not the same exact mate, but if you cannot find another one, you could try mine!

FOUND: Double Cut Spindle Gear for VIC III Motor

FOUND: Double Cut Spindle Gear for VIC III Motor

Re: WANTED: Double Cut Spindle Gear for VIC III Motor

Re: WANTED: Double Cut Spindle Gear for VIC III Motor

Re: FOUND: Double Cut Spindle Gear for VIC III Motor