Cygnet Crane for Triumph question

[bruv]

Does the triumph take a different crane for a cygnet horn than the Standards, Firesides, etc? I know it is supposed to have an 11 panel horn, but I have an extra 10 panel and I will be ok with that, but I need to get a crane and attaching hardware for the horn. The mounting bracket is already on the rear of the case. Is there a good dealer that might have the crane and spring and attaching hardware that I need? Thanks in advance for any help you may give.
Dave

[Jerry B.]

There are different sized cranes for each particular model depending on which reproducer and carriage is on that model. When you mix a smaller #10 Cygnet on a large Triumph plus not knowing the Triumph's carriage, it's a very difficult question to answer. I suspect that's why replies are slow.

Jerry B.

[Roaring20s]

viewtopic.php?f=2&t=46190&p=273185&hili ... od#p273185

What great information it would be if someone would lay the different types on top of each other and post photos and measurements to illustrate the differences? I have never seen anyone do this, not even those that sell reproductions! This is recurring mystery, asked over and over.

Other questions always asked is about the spring and/or hanger rod and the difference if it's a 10 or 11 panel horn.

Sounds like the making of an excellent educational article!

James.

[bruv]

Sorry for the lack of info. Here is a picture, not sure if this would give a person what is needed to figure out what crane I need with my 10 pannel. If this picture doesn't show what I have , what other info would be helpful to you guys who know so I can provide that.
Dave

P1050732.JPG (157 KiB) Viewed 399 times