Wanted: Cog for Graphophone AS

[Sidewinder]

Looking for this piece. Thanks

[JerryVan]

Do you have a sample of the gear so that it can be measured and reproduced?

[Sidewinder]

Do you have a sample of the gear so that it can be measured and reproduced?

Unfortunately not

[JerryVan]

Do you have a sample of the gear so that it can be measured and reproduced?

Unfortunately not

I sent you an email.

Okay... your email bounced back at me. I'll try a PM.

[JerryVan]

Frustrating. It appears that my PMs are not sending. Did you receive any?

Here is my message. Reply to my email address if interested...

"A friend of mine, and fellow forum member, has offered to let me use his AS gear as a sample. Please let me know if you have interest in having me make one for you, based off of his sample. The way I usually do these things is to make the part, ship it to the person to try out and be satisfied with it, then receive payment afterwards. I haven't been burned yet... I'll know better after I see the actual part to be copied what the cost might be."

Where are you located?


Thanks. Let me know,

Jerry Van
jerryvan65 yahoo.com

[kendphono]

I have some of these timing gears already made if you are interested.

Ken Danckaert

[dzavracky]

Frustrating. It appears that my PMs are not sending. Did you receive any?

Here is my message. Reply to my email address if interested...

"A friend of mine, and fellow forum member, has offered to let me use his AS gear as a sample. Please let me know if you have interest in having me make one for you, based off of his sample. The way I usually do these things is to make the part, ship it to the person to try out and be satisfied with it, then receive payment afterwards. I haven't been burned yet... I'll know better after I see the actual part to be copied what the cost might be."

Where are you located?


Thanks. Let me know,

Jerry Van
jerryvan65 yahoo.com

Jerry does awesome work! He is the only reason my Zonophone is currently working

Cheers,

David

[JerryVan]

Frustrating. It appears that my PMs are not sending. Did you receive any?

Here is my message. Reply to my email address if interested...

"A friend of mine, and fellow forum member, has offered to let me use his AS gear as a sample. Please let me know if you have interest in having me make one for you, based off of his sample. The way I usually do these things is to make the part, ship it to the person to try out and be satisfied with it, then receive payment afterwards. I haven't been burned yet... I'll know better after I see the actual part to be copied what the cost might be."

Where are you located?


Thanks. Let me know,

Jerry Van
jerryvan65 yahoo.com

Jerry does awesome work! He is the only reason my Zonophone is currently working

Cheers,

David

David,

Thank you. That means a lot to me.

[Sidewinder]

Hi, received your pm & replied - so as you say, may be issue with PM. I try email. Thanks