WANTED: Victor Crank Escutcheon

[JerryVan]

Looking for this style of Victor crank escutcheon. It does not have to look "perfect", because it's not going on a perfect machine. Some plating loss is fine but please, no deep rust or total loss of plating. Hope you can help. Thanks!

Vic.png (75.61 KiB) Viewed 246 times

[phonojim]

I think I have one. I'll try to look later today and get back to you.
Jim

[JerryVan]

That would be great. Thanks, Jim.

[phonojim]

Still looking....

[Phono-Phan]

Would any of these work? I think the one separated from the others is from a Victor horn machine and the tube section is worn through.

[JerryVan]

Would any of these work? I think the one separated from the others is from a Victor horn machine and the tube section is worn through.

I believe the separated one would be correct. Can you determine what the hole diameter might have been? THANKS!

[Phono-Phan]

Would any of these work? I think the one separated from the others is from a Victor horn machine and the tube section is worn through.

I believe the separated one would be correct. Can you determine what the hole diameter might have been? THANKS!

I will check today. I am having issues with this site locking up and not loading pages. Hopefully I can post the information later today.

[Phono-Phan]

½" I.D.

[snakeo1]

I'm helping out a friend...he needs one for a Victor XIV...not exactly sure about size...let me know if you know thanks.

[Phono-Phan]

I'm helping out a friend...he needs one for a Victor XIV...not exactly sure about size...let me know if you know thanks.

I would think that any of the ones in the column in the picture would work. It would need to be cleaned up. I can send you one Craig. Just let me know.