![[The Talking Machine Forum - For All Antique Phonographs & Recordings]](/styles/we_universal/theme/images/the_talking_machine_forum.png)
Hello,
I am new to the forum. I have inherited a beautiful table top Victrola model MS with a gorgeous oak horn. The only problem is that in the move the crank handle was lost. I am looking for a replacement. Any suggestions. It is a slotted crank that goes in through a hole in the side of the cabinet.
Help!
Victrola model MS crank replacment
-
mguelker53
- Victor Jr
- Posts: 1
- Joined: Mon Aug 22, 2011 4:46 pm
-
EdiBrunsVic
- Victor IV
- Posts: 1111
- Joined: Mon Jun 28, 2010 12:12 pm
- Location: Lubbock, Texas (again)
Re: Victrola model MS crank replacment
Welcome to the forum. You may want to check the "Links" section which will list some parts sources. This may help your search.
-
penman
- Victor II
- Posts: 271
- Joined: Sat Jun 18, 2011 9:27 am
- Location: Arizona
Re: Victrola model MS crank replacment
It's probably going to be tough finding an original, I've been looking for one for a long time without any luck 
, but there are several vendors who sell reproductions such as Phonophan, Phonographs.org, and others. There are links to some sites at the links section of the board. Good luck, I think the MS is both the best looking, and overall best outside horn machine Victor made. Good luck.
George
, but there are several vendors who sell reproductions such as Phonophan, Phonographs.org, and others. There are links to some sites at the links section of the board. Good luck, I think the MS is both the best looking, and overall best outside horn machine Victor made. Good luck.George