Oak base needed

briankeith · Post by **briankeith** » Fri Nov 18, 2011 12:04 pm

In need of an original or decent repro Oak wood base for one of my many little Edison Gems. Crank model if that matters. Thanks!

Stephen_Madara · Post by **Stephen_Madara** » Fri Nov 18, 2011 4:52 pm

I have one on a parts machine gem but i think it is a key-wind. I will try to send you a pic saturday night. Stephen

briankeith · Post by **briankeith** » Fri Nov 18, 2011 6:40 pm

Stephen, I know the Oak base attaches with four screws to the metal body - I wonder if key wind, crank wind, or even the age of the Edison Gems makes any difference with the base, etc? See photo:

Stephen_Madara · Post by **Stephen_Madara** » Sat Nov 19, 2011 2:56 pm

Here is the photo of the base that I have . Not sure if it is an original or not it looks like it might have been stripped before. Stephen

briankeith · Post by **briankeith** » Mon Nov 21, 2011 8:53 am

I guess I should send you the measurements from screw hole to screw hole. Stupid me. Sorry Stephen!!

Oak base needed

Oak base needed

Re: Oak base needed

Re: Oak base needed

Re: Oak base needed

Re: Oak base needed