Aeolian Vocalion reproducer elbow joint

[Microtrol]

Hi all,
I'm looking to see if any one has or can take some pictures of a intact elbow joint that connects the reproducer to the tone arm. I know that these are rare but if I can get a rough pic idea, I can model one up and have shape ways 3d print it for me. I have a pic of what is left of the one that i have and any help would be appreciated.

Brandt

[phonogal]

I have one that is intact. Let me know what pictures you need. Jan

[Microtrol]

Phonogal,
Thanks, that view is perfect as it gives me the angle. If you have time, a pic looking down at the elbow would be much appreciated.
Thanks again,
Brandt

[phonogal]

Here's a picture from the top. Sorry about the paint but that's how you get them sometimes. Let me know if you need any other pics. jan

[Microtrol]

Phonogal,
Many thanks for the pics of the elbow. I've modeled it up and sent it off to shape ways for a plastic proof before I have it done in alumide.

Thanks again, Brandt

[phonogal]

You're welcome. Glad I could help.

[Microtrol]

The shapeways part came in and it doesn't look too bad but I still have to finish the arm pin joint before I can play the Vocalion. Thanks again,

A few pics of the new joint