Edge curl on DDs

Share your phonograph repair & restoration techniques here
Post Reply
User avatar
Lucius1958
Victor Monarch
Posts: 4036
Joined: Tue Dec 14, 2010 12:17 am
Location: Where there's "hamburger ALL OVER the highway"...

Edge curl on DDs

Post by Lucius1958 »

I'm wondering whether the plate glass / sunlight technique might also work to remedy edge curl on Diamond Discs? I've done a brief experiment (on an unplayable disc, natch) with a hot knife; and it seems to have a slight effect...

Bill

gramophoneshane
Victor VI
Posts: 3463
Joined: Wed Jan 07, 2009 3:21 pm

Re: Edge curl on DDs

Post by gramophoneshane »

I have a feeling exposing dd's to sunlight would only make the problem worse, though I could be wrong.
I doubt there's anything that could fix the problem on a long term basis.

User avatar
VintageTechnologies
Victor IV
Posts: 1651
Joined: Thu Jul 14, 2011 12:09 pm

Re: Edge curl on DDs

Post by VintageTechnologies »

I have seen edge curl mostly on the older black etched label records. Edison disks are not made from shellac like the 78's; rather, the laminated surface is an Edison equivalent of Bakelite and therefore eating it may not do it any good.

User avatar
Lucius1958
Victor Monarch
Posts: 4036
Joined: Tue Dec 14, 2010 12:17 am
Location: Where there's "hamburger ALL OVER the highway"...

Re: Edge curl on DDs

Post by Lucius1958 »

VintageTechnologies wrote:I have seen edge curl mostly on the older black etched label records. Edison disks are not made from shellac like the 78's; rather, the laminated surface is an Edison equivalent of Bakelite and therefore eating it may not do it any good.
True, these are late 'transfer' discs. They were actually pressed on celluloid coated with Condensite varnish, which was then bonded to the core. Since celluloid is a thermoplastic, I wondered whether the proper application of heat might soften this enough to enable the edge to be pressed back down.

It's likely that celluloid softens at a higher temperature than shellac; and of course the Condensite may not soften at all....

-Bill

Post Reply