Edison Gem

Discussions on Talking Machines & Accessories
Post Reply
Dave D
Victor IV
Posts: 1302
Joined: Wed Aug 01, 2012 8:43 pm
Location: Port Huron, MI

Edison Gem

Post by Dave D »

I just found an Edison Gem with a banner lid. It is serial number G145780. Is the banner lid correct for this? I need a piece of lid molding, too if anyone has a junker lid. The piece on need is on the right side, the small piece at the back. Thanks!
Dave D
Top
Jerry B.
Victor Monarch Special
Posts: 8716
Joined: Tue Feb 10, 2009 11:25 am
Personal Text: Stop for a visit when in Oregon.
Location: Albany, Oregon

Re: Edison Gem

Post by Jerry B. »

A Gem lid with a banner label spanned the later Gem A's to the early B's. Any Gem with a key will not have a slot in the lid while every crank wound Gem will have a slot in the lid for the crank. I hope this helps. Jerry
Top
Dave D
Victor IV
Posts: 1302
Joined: Wed Aug 01, 2012 8:43 pm
Location: Port Huron, MI

Re: Edison Gem

Post by Dave D »

So, this is probably the right lid for this machine. Good to know.
Thanks for the reply. Anybody got the molding for me?
Dave D
Top
gramophone78
Victor VI
Posts: 3946
Joined: Mon Nov 16, 2009 9:42 am
Location: Western Canada

Re: Edison Gem

Post by gramophone78 »

Dave D wrote:So, this is probably the right lid for this machine. Good to know.
Thanks for the reply. Anybody got the molding for me?
Dave D

Place an ad in our "Yankee Trader" section of our forum so members can see what part your looking for :).
Top
Post Reply

Return to “Machines”