WTB Edison B Carrage arm

[edisonrestorer64]

this is the carrage arm i need for my B home. this one is broken tried reparing it did not work

I want the one with the leaver on side as pictured below. However but not broken mine broke and is un repairable.
Thank You for any and all help

[Chuck]

Never say never...

I know a gentleman who works magic with brazing
cast iron. That carriage could most likely
be repaired.

Chuck

[edisonrestorer64]

Hello Chuck it rebroke after i used JBweld it just did not slide right on the bar . It is suppose to slide smoothly on the bar Ill send it if it does not cost too much to repair. My Mom is in Icu unit at the hospital so funding is very tight at this time
Thank Sincerely william
PS Please let me know either way on this if he can do this great but please it has to be mended properly so it glises accross on the bar
again Much Thanks

[joybird]

If Braze not available. I would Gel glue it in proper position and drill and insert 2 small expansion pins. Then you could JB weld it also.
Be aware JB Weld does not like oil. The cast needs to be very clean.

Have used this procedure many times


Good luck with it.

Bob T

[Chuck]

Sent you a PM.

Chuck

[mark gaisser]

HEY CHUCK....I HAVE THOSE IN STOCK FOR $25.00 IF YOU WANT ONE...IT SAVE TIME JUST BUYING ANOTHER ONE...IF YOU WANT IT EMAIL ME AT [email protected] .
HAPPY NEW YEARS,
MARK AND DARCY
CROAKINFROG PHONOGRAPHS

[edisonrestorer64]

Hello Mark I also sent one
sincerely Bill PS I purchased the Bedplate rememeber the ebay guy Me LOL