WTB-Victor 2 spring Motor Spindle Shaft

Buy, sell, or trade your phonograph-related items here [except music]
Post Reply
User avatar
mattrx
Victor IV
Posts: 1161
Joined: Wed Oct 12, 2011 9:55 am
Location: Bartlett, TN

WTB-Victor 2 spring Motor Spindle Shaft

Post by mattrx »

I am trying to rehab a Vic III. I believe the spindle shaft is bent slightly. Any chance anyone out there has a shaft for this type of motor? If not, has anyone had any luck at straightening one? The shaft is 6 inches long from a Vic III, circa 1910 (from what I can tell from Victor Data Book). As always, any help is appreciated.
Attachments
Untitled11.png

downsouth
Victor III
Posts: 780
Joined: Wed May 06, 2009 10:04 pm

Re: WTB-Victor 2 spring Motor Spindle Shaft

Post by downsouth »

Matt, I have had two or three spindle shafts straightened in the past by a machinist friend of mine.He did a great job. I would not try to find another one, straitening one can be done.

Regards, Wes

Post Reply