WANTED: Specifications for Victor E Motor Board Arm

Buy, sell, or trade your phonograph-related items here [except music]
Post Reply
User avatar
Lucius1958
Victor Monarch
Posts: 4040
Joined: Tue Dec 14, 2010 12:17 am
Location: Where there's "hamburger ALL OVER the highway"...

WANTED: Specifications for Victor E Motor Board Arm

Post by Lucius1958 »

Since i am unlikely to find an original for this, I thought I would ask whether I might get the specifications for the motor board support arm on my Victor E.

I have a rough idea of the necessary length, but if anyone could supply more accurate dimensions (width, thickness etc.), I would be grateful.

I would assume that the arm was originally riveted to its bracket, although it is hard to imagine how they could have become separated; I suppose I shall have to use a nut and bolt of suitable size.

Bill

User avatar
Phonolair
Victor III
Posts: 615
Joined: Wed Jan 07, 2009 4:23 pm
Location: Michigan

Re: WANTED: Specifications for Victor E Motor Board Arm

Post by Phonolair »

Hi Bill
If you still need the support arm send me your address and I will mail one to you. After you get the support arm if you would send me back a few bucks for the padded envelope and shipping we'll be good.
Best Regards, Larry

User avatar
Lucius1958
Victor Monarch
Posts: 4040
Joined: Tue Dec 14, 2010 12:17 am
Location: Where there's "hamburger ALL OVER the highway"...

Re: WANTED: Specifications for Victor E Motor Board Arm

Post by Lucius1958 »

PM sent. Thanks!

Bill

Post Reply