Brunswick Model YO spring repair

Hearsug · Post by **Hearsug** » Tue Jan 14, 2014 9:15 am

I am rebuilding the spring motor on my recently acquired Brunswick Model YO phonoghaph. It appears to be in very good condition, all of the gears, etc. operate freely. Could someone please explain how to disassemble the 2 piece spring housing?

Post by **alang** » Tue Jan 14, 2014 9:32 am

Pictures will always help others to better understand the problem and give advice.
Good luck
Andreas

Hearsug · Post by **Hearsug** » Tue Jan 14, 2014 10:34 am

Good idea. The attached photo is of the spring housing assembly.

Hearsug · Post by **Hearsug** » Tue Jan 14, 2014 10:40 am

attached photo in .jpg

Hearsug · Post by **Hearsug** » Tue Jan 14, 2014 1:05 pm

Maybe it is properly called a spring barrel?

Bob · Post by **Bob** » Tue Jan 14, 2014 1:20 pm

I would put the the side with the smaller gear into a vise. Take a piece of wood and a hammer. Tap around the part that overlaps the other to separate the two halves.

Henry · Post by **Henry** » Tue Jan 14, 2014 1:43 pm

I'd put it in a vise. A vice might be illegal!

Brunswick Model YO spring repair

Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair

Re: Brunswick Model YO spring repair