Page 2 of 2
Re: Harmony Governor Adjustment
Posted: Tue Apr 15, 2025 6:44 pm
by JerryVan
colmike1 wrote: Tue Apr 15, 2025 5:41 pm
Jerry,
I have removed the lower support ( see photos) and nothing seems too worn or damaged. I even swapped a spare support from a parts motor from an Arentino and still the same issue.
Mike
Did you check the 11/32" dimension?
Re: Harmony Governor Adjustment
Posted: Tue Apr 15, 2025 10:44 pm
by Lucius1958
Not my area of expertise, but:
What's the overall length of the spindle shaft in the OP's machine, compared to the other shown?
Also, the taper on the spindle end seems to differ between the two: could that be a sign of repair?
- Bill
Re: Harmony Governor Adjustment
Posted: Wed Apr 16, 2025 6:35 am
by JerryVan
Lucius1958 wrote: Tue Apr 15, 2025 10:44 pm
Not my area of expertise, but:
What's the overall length of the spindle shaft in the OP's machine, compared to the other shown?
Also, the taper on the spindle end seems to differ between the two: could that be a sign of repair?
- Bill
Those are my thoughts as well.
Re: Harmony Governor Adjustment
Posted: Sat May 03, 2025 4:43 pm
by colmike1
Sorry for the delay, this is my busy season ( we conduct estate sales and auctions). The spindle measures 7/16”