Spring leaf

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 1:48 pm

Thank you for sharing your enlightening and well stated perspective!
[/quote]

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 2:03 pm

AZ* wrote: Mon Nov 14, 2022 12:30 pm

I could not agree more.
Well I would love to know more about the book that you have mentioned.
I guess the measurement tape is usually 0.009 inches or 9.23 mm.
Thanks

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 2:07 pm

Hoodoo wrote: Sun Nov 13, 2022 8:31 am I forget the seller I bought my spring steel from, but just search for “spring steel strip” on Ebay, you will find all sorts of sizes and thicknesses for low prices and cheap shipping.
See screenshot.

Thanks for your suggestion

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 2:12 pm

Zkeener323 wrote: Mon Nov 14, 2022 12:57 pm Those were amazing articles! As to your springs- I'm not an expert but they look top quality. Amazing craftmanship, if shipping wasn't so expensive, I would gladly buy from you.

anchorman · Post by **anchorman** » Mon Nov 14, 2022 5:21 pm

Nice work! They do look a little inconsistent with the side to side spacing of the holes, so it might pay to refine the jig a little bit to get everything centered just right. Every little bit helps in getting things easily balanced and keeping the spring strength consistent.

anchorman · Post by **anchorman** » Mon Nov 14, 2022 5:26 pm

Just a data point to add here, every governor spring that I’ve measured so far has been 0.0065” / 0.16mm thick.

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 11:14 pm

anchorman wrote: Mon Nov 14, 2022 5:26 pm Just a data point to add here, every governor spring that I’ve measured so far has been 0.0065” / 0.16mm thick.

Yes that is the correct size and the one used in measuring tapes.
Cheers

Sherazhyder · Post by **Sherazhyder** » Mon Nov 14, 2022 11:15 pm

anchorman wrote: Mon Nov 14, 2022 5:21 pm Nice work! They do look a little inconsistent with the side to side spacing of the holes, so it might pay to refine the jig a little bit to get everything centered just right. Every little bit helps in getting things easily balanced and keeping the spring strength consistent.

I will take care of this too

anchorman · Post by **anchorman** » Mon Nov 14, 2022 11:35 pm

Looking forward to seeing the progress! One thing I’ve never done much with is metal punches to make holes. Looks like a very handy skill/tools to have.

I am interested in mainsprings at the moment, but can’t find an inexpensive source of the 301 stainless steel spring stock that I want to experiment with.

Sherazhyder · Post by **Sherazhyder** » Tue Nov 15, 2022 3:48 am

For punching square or round hole, the best tools are (I) bench stand for ordinary drill machine and (II) square or round hole bit/punchers of the specific hole size. These two item are cheaply available at ali express and daraz. I am not sure but someone mentioned here about the availability of steel strip on eBay on very economical rates. Best

Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf

Re: Spring leaf