
Time to unload
-
- Victor IV
- Posts: 1228
- Joined: Fri Jun 08, 2012 1:14 pm
Time to unload
Time has come to unload a bunch of my stuff. Collecting machines since 80, not as an investment, just enjoyed the hunt and working on them. Going to unload about 15 Victrolas, shipping crate, etc. I haven't sensed any excitement from the several auction houses I contacted over the past few months. Figure I'll call one of the more popular places and tell them to come get'em. No doubt I shall take a drubbing but it is what it is. If these initial 15 go then the rest will follow. Wish me luck 

- m0xiemama
- Victor II
- Posts: 363
- Joined: Wed Jul 18, 2012 12:56 am
- Location: Pittsburgh, PA
Re: Time to unload
Why not list em here first and see what comes of it? Too much work?
-
- Victor IV
- Posts: 1107
- Joined: Mon Jun 28, 2010 12:12 pm
- Location: Lubbock, Texas (again)
Re: Time to unload
You possibly could list them in the Yankee Trader section.
-
- Victor IV
- Posts: 1228
- Joined: Fri Jun 08, 2012 1:14 pm
Re: Time to unload
Thats a thought. I'm going to list what is going, so might as well put them on YT prior to calling the Auction folks. Thanks
-
- Victor O
- Posts: 92
- Joined: Sat Jan 10, 2009 1:01 pm
- Location: SW Montana
Re: Time to unload
I am sure that listing here on the forum would create real interest. Creates some additional work for you with the S&H issue, but expenses could be taken into account with your pricing. New members are always looking to expand their collection.
-
- Auxetophone
- Posts: 2587
- Joined: Wed Jan 14, 2009 5:01 am
Re: Time to unload
Old members are always looking to expand as wellGleemanguy wrote:New members are always looking to expand their collection.

- Nat
- Victor III
- Posts: 598
- Joined: Fri Aug 07, 2009 12:02 pm
- Location: Edmonds, Washington
Re: Time to unload
In either case, they'd be going into the right hands!
-
- Victor IV
- Posts: 1228
- Joined: Fri Jun 08, 2012 1:14 pm
Re: Time to unload
Ok I'll get cracking on this - thanks for the responses.....cheers
-
- Victor III
- Posts: 564
- Joined: Tue Jul 23, 2013 2:44 pm
- Location: Missouri
Re: Time to unload
What do you have to unload??