Back casting screw... Exhibition same as #2?

banjo_picker · Post by **banjo_picker** » Wed Mar 12, 2014 9:04 am

As I understand it, there are three screws that hold the two halves of an Exhibition reproducer together, and four that hold a #2 together. Are the screws interchangable between the two models? That is, with the Exhibition screws work in the #2?

Phonolair · Post by **Phonolair** » Wed Mar 12, 2014 1:51 pm

No, these screws are completely different from each other and are not interchangeable. The diameter of the screws are different as are the heads of the screws also.
Best Regards, Larry

banjo_picker · Post by **banjo_picker** » Wed Mar 12, 2014 1:57 pm

Ok.. thanks for the info!

Back casting screw... Exhibition same as #2?

Back casting screw... Exhibition same as #2?

Re: Back casting screw... Exhibition same as #2?

Re: Back casting screw... Exhibition same as #2?