Page 1 of 1
Back casting screw... Exhibition same as #2?
Posted: Wed Mar 12, 2014 9:04 am
by banjo_picker
As I understand it, there are three screws that hold the two halves of an Exhibition reproducer together, and four that hold a #2 together. Are the screws interchangable between the two models? That is, with the Exhibition screws work in the #2?
Re: Back casting screw... Exhibition same as #2?
Posted: Wed Mar 12, 2014 1:51 pm
by Phonolair
No, these screws are completely different from each other and are not interchangeable. The diameter of the screws are different as are the heads of the screws also.
Best Regards, Larry
Re: Back casting screw... Exhibition same as #2?
Posted: Wed Mar 12, 2014 1:57 pm
by banjo_picker
Ok.. thanks for the info!