Page 1 of 1
WANTED: Long Piece of Lid Molding for Edison Standard A
Posted: Thu Nov 20, 2014 12:12 pm
by Jerry B.
I need one piece of long lid molding for an Edison Standard Model A. It should have a green tint to the finish. Please take a moment to check. It's all I need to complete a nice little ICS machine. Anyone? Thanks, Jerry
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Posted: Thu Nov 20, 2014 12:15 pm
by martinola
Hi Jerry.
Can you post a picture of the remaining molding's profile? There were at least two different types.
Regards,
Martin
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Posted: Thu Nov 20, 2014 1:51 pm
by Jerry B.
Thanks, I wasn't aware there were two different molding for the green case A. Here are photos. Thanks, Jerry
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Posted: Thu Nov 20, 2014 10:05 pm
by gsphonos
Got one for you Jerry. Just haven't had any luck e-mailing you. I even tried the other e-mail address you left me on a phone message. Sorry, just haven't had time to call. I'll talk to you in the next couple of days!
Mike
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Posted: Thu Nov 20, 2014 10:31 pm
by martinola
It looks like you have the earlier style with the smoothed top edge as opposed to the beaded top edge as seen on the model Bs on up. I have a couple of repro pieces of the later style, but not this one.
Regards,
Martin