WANTED: Long Piece of Lid Molding for Edison Standard A

Jerry B. · Post by **Jerry B.** » Thu Nov 20, 2014 12:12 pm

I need one piece of long lid molding for an Edison Standard Model A. It should have a green tint to the finish. Please take a moment to check. It's all I need to complete a nice little ICS machine. Anyone? Thanks, Jerry

martinola · Post by **martinola** » Thu Nov 20, 2014 12:15 pm

Hi Jerry.
Can you post a picture of the remaining molding's profile? There were at least two different types.
Regards,
Martin

Jerry B. · Post by **Jerry B.** » Thu Nov 20, 2014 1:51 pm

Thanks, I wasn't aware there were two different molding for the green case A. Here are photos. Thanks, Jerry

gsphonos · Post by **gsphonos** » Thu Nov 20, 2014 10:05 pm

Got one for you Jerry. Just haven't had any luck e-mailing you. I even tried the other e-mail address you left me on a phone message. Sorry, just haven't had time to call. I'll talk to you in the next couple of days!

Mike

martinola · Post by **martinola** » Thu Nov 20, 2014 10:31 pm

It looks like you have the earlier style with the smoothed top edge as opposed to the beaded top edge as seen on the model Bs on up. I have a couple of repro pieces of the later style, but not this one.

Regards,
Martin

WANTED: Long Piece of Lid Molding for Edison Standard A

WANTED: Long Piece of Lid Molding for Edison Standard A

Re: WANTED: Long Piece of Lid Molding for Edison Standard A

Re: WANTED: Long Piece of Lid Molding for Edison Standard A

Re: WANTED: Long Piece of Lid Molding for Edison Standard A

Re: WANTED: Long Piece of Lid Molding for Edison Standard A