WANTED: Long Piece of Lid Molding for Edison Standard A
-
- Victor Monarch Special
- Posts: 8716
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
WANTED: Long Piece of Lid Molding for Edison Standard A
I need one piece of long lid molding for an Edison Standard Model A. It should have a green tint to the finish. Please take a moment to check. It's all I need to complete a nice little ICS machine. Anyone? Thanks, Jerry
-
- Victor III
- Posts: 961
- Joined: Wed Feb 11, 2009 1:30 pm
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Hi Jerry.
Can you post a picture of the remaining molding's profile? There were at least two different types.
Regards,
Martin
Can you post a picture of the remaining molding's profile? There were at least two different types.
Regards,
Martin
-
- Victor Monarch Special
- Posts: 8716
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Thanks, I wasn't aware there were two different molding for the green case A. Here are photos. Thanks, Jerry
-
- Victor II
- Posts: 420
- Joined: Wed Feb 24, 2010 11:33 pm
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
Got one for you Jerry. Just haven't had any luck e-mailing you. I even tried the other e-mail address you left me on a phone message. Sorry, just haven't had time to call. I'll talk to you in the next couple of days!
Mike
Mike
-
- Victor III
- Posts: 961
- Joined: Wed Feb 11, 2009 1:30 pm
Re: WANTED: Long Piece of Lid Molding for Edison Standard A
It looks like you have the earlier style with the smoothed top edge as opposed to the beaded top edge as seen on the model Bs on up. I have a couple of repro pieces of the later style, but not this one.
Regards,
Martin
Regards,
Martin