Page 1 of 2
WANTED: Early style flat Victrola VV-IV crank
Posted: Mon Nov 30, 2015 10:01 am
by benjaminh
I'm looking for an early style flat Victrola VV-IV crank? Anyone have an available one?
Benjamin
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Thu Dec 03, 2015 4:48 pm
by benjaminh
bump
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sat Dec 05, 2015 11:14 pm
by benjaminh
No one have one? I'm also looking for the matchine estucheon.
Benjamin
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sat Dec 05, 2015 11:32 pm
by alang
Have you tried George Vollema of Great Lakes Phonograph or Ron Sitko?
Good luck
Andreas
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sat Dec 05, 2015 11:40 pm
by benjaminh
I've tried George Vollema, but unfortunately Ron Sitko, who I usually use, is away(or closed) until the beginning of January. George Vollema only has repros for $40. I'd like to find an original if possible.
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sun Dec 06, 2015 12:47 pm
by Phonofreak
Ben, There are 2 different thread sizes for this crank. The early one used a ¼" thread. The later ones used a 3/16" thread. Post a picture of your machine with the S/N, and I can help you find the right crank.
Harvey Kravitz
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Mon Dec 07, 2015 9:29 am
by benjaminh
Here's the info: the serial number is “150051 E” and pictures showing crank location are included below.
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Fri Dec 11, 2015 10:13 pm
by benjaminh
Bump
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sat Dec 12, 2015 7:57 am
by a12548
Actually the early IV cranks were 5/16" female
Re: WANTED: Early style flat Victrola VV-IV crank
Posted: Sat Dec 12, 2015 8:48 am
by Bob
I have 2 cranks and one might be what you need. The longer one is 5/16-24 thread and the shorter one is ¼. The longer one is 5" long and the shorter is 3 ⅞" long. Not sure what model they are for.
Bob