Round Speed Control Knob Problem

Discussions on Talking Machines & Accessories
Post Reply
Victrolacollector
Victor V
Posts: 2711
Joined: Fri Nov 18, 2011 11:23 pm
Location: NW Indiana VV-IV;

Round Speed Control Knob Problem

Post by Victrolacollector »

I have a VV-XI tabletop and the round speed control knob is adjusted and works fine except the 76 is closest to the turntable with the needle pointing at 76 toward the turntable. Is this correct? Should'nt the needle point out away from the turntable at 76? If it should is there away to turn the round plate correctly?
Top
User avatar
howardpgh
Victor II
Posts: 434
Joined: Sun Mar 10, 2013 4:34 pm
Location: Pittsburgh

Re: Round Speed Control Knob Problem

Post by howardpgh »

On my Victor IV I think the 76 is right side up and is at front right corner of the motor board.
See if this is helpful
http://forum.talkingmachine.info/viewto ... ed+control
Top
Post Reply

Return to “Machines”