WANTED: Victor I Reproducer Arm

Canuk Phonographs: Victor II; Posts: 288; Joined: Sun May 10, 2015 10:35 pm; Location: Stratford Ontario

Quote

Post by Canuk Phonographs » Sat Jul 01, 2017 4:49 pm

I would like to buy a Victor 1 reproducer arm complete as shown in the picture. If the nickel plating is gone, that is no problem as I can get it re-plated. The overall length is approximately 8 in. and the diameter of the arm is 1 in. at the end that inserts into the back bracket.

Thanks in advance.

Blain

Attachments