Wanted

[Electrolaman]

Looking for motor, motor board turntable and crank for a Standard talking machine model H.

[outune]

Hi- I have a Standard Talking Machine motor (well, most of the motor)- I don't know what model it is for. It needs a mainspring and governor weights/springs-- Otherwise, I believe it is complete. Fiber spindle gear looks good.
Is this helpful to you?

Brad Abell

DSCN5702.JPG (139.24 KiB) Viewed 558 times

DSCN5703.JPG (137.27 KiB) Viewed 558 times

DSCN5704.JPG (137.7 KiB) Viewed 558 times

DSCN5705.JPG (137.02 KiB) Viewed 558 times

[schweg]

Model H has 2 springs. The one pictured above may be for a Model L. It has a single spring. The Intertique web page shows both.

[Jerry B.]

I've got a 10" cast turntable, with a thick edge, for a Standard disc machine. Someone drilled a hole into the spindle cap but that could be filled.

Jerry B.

[outune]

Thanks Schweg-- I didn't know which model my motor would fit--
The motor frame has holes spaced out to allow the post that supports the spring barrel to be mounted in different positions for one, two or three barrels-- but the winding shaft would be different for each set up-

I do have an extra winding shaft that would be correct for the two spring set up (1st picture)-- but I don't have the extra correct spring barrel.

DSCN5706.JPG (136.89 KiB) Viewed 396 times

The other two pics show some of the Columbia/STM/Client parts I have. All are available cheap for anyone who may need them.

DSCN5707.JPG (136.24 KiB) Viewed 396 times

DSCN5708.JPG (137.63 KiB) Viewed 396 times

Brad Abell