Page 1 of 1
Wanted
Posted: Tue Jul 05, 2022 9:33 pm
by Electrolaman
Looking for motor, motor board turntable and crank for a Standard talking machine model H.
Re: Wanted
Posted: Wed Jul 06, 2022 12:20 pm
by outune
Hi- I have a Standard Talking Machine motor (well, most of the motor)- I don't know what model it is for. It needs a mainspring and governor weights/springs-- Otherwise, I believe it is complete. Fiber spindle gear looks good.
Is this helpful to you?
Brad Abell
- DSCN5702.JPG (139.24 KiB) Viewed 563 times
- DSCN5703.JPG (137.27 KiB) Viewed 563 times
- DSCN5704.JPG (137.7 KiB) Viewed 563 times
- DSCN5705.JPG (137.02 KiB) Viewed 563 times
Re: Wanted
Posted: Thu Jul 07, 2022 9:26 am
by schweg
Model H has 2 springs. The one pictured above may be for a Model L. It has a single spring. The Intertique web page shows both.
Re: Wanted
Posted: Thu Jul 07, 2022 11:19 am
by Jerry B.
I've got a 10" cast turntable, with a thick edge, for a Standard disc machine. Someone drilled a hole into the spindle cap but that could be filled.
Jerry B.
Re: Wanted
Posted: Thu Jul 07, 2022 12:55 pm
by outune
Thanks Schweg-- I didn't know which model my motor would fit--
The motor frame has holes spaced out to allow the post that supports the spring barrel to be mounted in different positions for one, two or three barrels-- but the winding shaft would be different for each set up-
I do have an extra winding shaft that would be correct for the two spring set up (1st picture)-- but I don't have the extra correct spring barrel.
- DSCN5706.JPG (136.89 KiB) Viewed 401 times
The other two pics show some of the Columbia/STM/Client parts I have. All are available cheap for anyone who may need them.
- DSCN5707.JPG (136.24 KiB) Viewed 401 times
- DSCN5708.JPG (137.63 KiB) Viewed 401 times
Brad Abell