Page 1 of 1
Edison Gem Question
Posted: Sat Apr 19, 2025 12:35 pm
by paradroid1793
I recently picked up this Edison Gem. After replacing the belt the mandrel spins fine. However, I am missing the crank it seems. What’s odd is that this hole did not accept a typical male or female crank. What is supposed to go here? Thanks.
Re: Edison Gem Question
Posted: Sat Apr 19, 2025 1:29 pm
by phonogfp
That's a Model A Gem, which uses a key.
George P.
Re: Edison Gem Question
Posted: Sat Apr 19, 2025 1:41 pm
by DanP58
Saw this on eBay today
Dan
Re: Edison Gem Question
Posted: Sat Apr 19, 2025 1:45 pm
by paradroid1793
I ordered a new key. Thanks.
Re: Edison Gem Question
Posted: Sat Apr 19, 2025 4:30 pm
by JerryVan
paradroid1793 wrote: Sat Apr 19, 2025 1:45 pm
I ordered a new key. Thanks.
The one shown above is not the key you need.
This is what you need...