WTB Oak lid and back panel for Victrola XIV

antique1973 · Post by **antique1973** » Thu Mar 15, 2012 2:29 am

This would be for a model with the latest cabinet style.

Jerry B. · Post by **Jerry B.** » Wed Mar 21, 2012 12:27 am

Probably many of us have an extra lid or two. Can you give the outside dimensions of the cabinet where the lid meets the cabinet. Thanks, Jerry

antique1973 · Post by **antique1973** » Wed Mar 21, 2012 8:26 pm

Sure thing! The top of the cabinet where the lid sits on is 19 and 3/4th inches across the front
and 21.5 inches from front to the back. I am also missing a nickel keyhole escutcheon in case anyone
has a spare. This one was weird. I pulled the springs and found them to be spotless clean but no
grease at all. Someone probably sprayed WD-40 in there or something and it just evaporated. The governor
was shot too so I put a spare in and now it runs smooth.

Jerry B. · Post by **Jerry B.** » Thu Mar 22, 2012 12:25 pm

I just came down from my attic and I have a large Victrola lid that measures 19.75" across and 22.5" deep and it's fumed oak. Mine is a little long compared to your measurements but it's yours if it helps. Jerry Blais

WTB Oak lid and back panel for Victrola XIV

WTB Oak lid and back panel for Victrola XIV

Re: WTB Oak lid and back panel for Victrola XIV

Re: WTB Oak lid and back panel for Victrola XIV

Re: WTB Oak lid and back panel for Victrola XIV