Page 1 of 1
WTB Oak lid and back panel for Victrola XIV
Posted: Thu Mar 15, 2012 2:29 am
by antique1973
This would be for a model with the latest cabinet style.
Re: WTB Oak lid and back panel for Victrola XIV
Posted: Wed Mar 21, 2012 12:27 am
by Jerry B.
Probably many of us have an extra lid or two. Can you give the outside dimensions of the cabinet where the lid meets the cabinet. Thanks, Jerry
Re: WTB Oak lid and back panel for Victrola XIV
Posted: Wed Mar 21, 2012 8:26 pm
by antique1973
Sure thing! The top of the cabinet where the lid sits on is 19 and 3/4th inches across the front
and 21.5 inches from front to the back. I am also missing a nickel keyhole escutcheon in case anyone
has a spare. This one was weird. I pulled the springs and found them to be spotless clean but no
grease at all. Someone probably sprayed WD-40 in there or something and it just evaporated. The governor
was shot too so I put a spare in and now it runs smooth.
Re: WTB Oak lid and back panel for Victrola XIV
Posted: Thu Mar 22, 2012 12:25 pm
by Jerry B.
I just came down from my attic and I have a large Victrola lid that measures 19.75" across and 22.5" deep and it's fumed oak. Mine is a little long compared to your measurements but it's yours if it helps. Jerry Blais