Victrola No. 4 Reproducer....Did I pay too much??

Victrolacollector · Post by **Victrolacollector** » Wed Aug 12, 2015 8:42 pm

I was watching a Victrola No. 4 reproducer on e-bay, it is the Victrola No. 4 not the "4A" made of pot metal. I put in bids, and finally threw in my max of $251.00 and it closed at $ 251.00. Also, I bought the gaskets, diaphragm and back insert from Walt Sommers, so it all runs an additional $ 20.00 give or take. I will have about $ 271.00 into this. I am wondering if I paid too much for it?

Phonofreak · Post by **Phonofreak** » Wed Aug 12, 2015 9:38 pm

If this is the all brass Victrola IV reproducer, you did good. That is what they go for.
Harvey kravitz

daverob · Post by **daverob** » Wed Aug 12, 2015 9:40 pm

http://forum.talkingmachine.info/viewto ... f=2&t=7413

daverob · Post by **daverob** » Wed Aug 12, 2015 9:41 pm

Hey that's you!

Victrolacollector · Post by **Victrolacollector** » Thu Aug 13, 2015 6:00 pm

Yep! It is brass. Thanks for the advice.

Phonofreak · Post by **Phonofreak** » Thu Aug 13, 2015 8:54 pm

Victrolacollector wrote:Yep! It is brass. Thanks for the advice.

That's great. Glad to hear it. These are rare, and you got a bargain.
Harvey Kravitz

Victrola No. 4 Reproducer....Did I pay too much??

Victrola No. 4 Reproducer....Did I pay too much??

Re: Victrola No. 4 Reproducer....Did I pay too much??

Re: Victrola No. 4 Reproducer....Did I pay too much??

Re: Victrola No. 4 Reproducer....Did I pay too much??

Re: Victrola No. 4 Reproducer....Did I pay too much??

Re: Victrola No. 4 Reproducer....Did I pay too much??