Wanted: Victor “Remove this plate to attach rigid arm” plate

[Crank_it_up]

I still have this one for sale. $85
viewtopic.php?f=9&t=35245
Thanks, Joe

Sorry, I realize mine is not correct, it’s for a tapering arm upgrade not a rigid arm.
Joe

[gramophone78]

Just to get back to the OP's "wanted" post....I think Mark already mentioned on the first page the plate needed is for sale on Ebay.

Hope it helps complete your new machine... .

https://www.ebay.com/itm/VICTOR-DISC-PH ... asc%3D2016

[Jerry B.]

Sorry, I realize mine is not correct, it’s for a tapering arm upgrade not a rigid arm.
Joe

Yes, but at some point or serial number your tag would have been appropriate on a front mount Victor E. I wonder what that serial number would be. I checked my Victor E with a serial number of 62,xxx and it's a tapered arm example and was not drilled for a front mount.

Jerry B.

[drboruff]

For reference, I have a late front mount E with a "taper arm" tag and the s/n is 58,xxx.
David

[Phonolair]

[/quote]Yes, but at some point or serial number your tag would have been appropriate on a front mount Victor E. I wonder what that serial number would be. I checked my Victor E with a serial number of 62,xxx and it's a tapered arm example and was not drilled for a front mount.

Jerry B.[/quote]

A bit more information. I have a Victor E #60453 that is a rear mount only. Never drilled for the front mount.

Larry Crandell

[Pertz]

I haven’t spotted another “Remove” brass plate on Ebay since 2019...