Edison 2-4 minute conversion

[DanP58]

Can anyone tell me what the set screw (letter s on instruction sheet) looks like , it replaces the round head set screw on cylinder shaft? I didn’t get it with the kit I purchased ? Any idea where I can find one? Haven’t had much luck searching so far. Thanks
Dan

[MisterGramophone]

I don’t know, what model machine do you have? A converter isn’t that good, a fireside would be pretty easy to convert and if you have a 4 minute machine too, you don’t need a converter.

[JerryVan]

Can anyone tell me what the set screw (letter s on instruction sheet) looks like , it replaces the round head set screw on cylinder shaft? I didn’t get it with the kit I purchased ? Any idea where I can find one? Haven’t had much luck searching so far. Thanks
Dan

Can you show us a picture of the instruction sheet, depicting the "letter s" set screw?

[FellowCollector]

Can anyone tell me what the set screw (letter s on instruction sheet) looks like

If you can share a picture of the instruction sheet showing the set screw that you're referring to we can surely help. I presume this is for an Edison Standard 2/4 min conversion.

Doug

[DanP58]

Ok here’s two photos , description and parts

In some pictures online it looks like a shorter flat screw ???

[FellowCollector]

If you're referring to this set screw circled in the picture I provided it is a very vital screw that secures the "new" mandrel shaft bearing to the upper casting. Perhaps Parlier has one of these screws. The assembly won't function correctly without it.

[DanP58]

Yep I found that out , it’s probably a standard size thread looks like 4-40 but I’m not sure of length or head style that will fit under the mechanism. I’ll check with Brian P thanks

[MarkELynch]

The thread size is 5-40 but you won’t find that size in most hardware stores.

We have covered a similar topic previously.

viewtopic.php?f=2&t=53317&p=317098&hilit=Thread#p317098

If you can’t locate what you need elsewhere I can send a slotted 5-40 set screw, I bought a small quantity from Blacksmith Bolt and Rivet.

Mark

[DanP58]

Mark That would be great , I’ll be able to get it working until, if and when I find an original screw . Let me know the cost and shipping. Thanks Dan

Dan Powers
223 Hamilton Ave
Hasbrouck Heights New Jersey
07604

[DanP58]

Thanks Mark, I received the screw and it works fine
Dan