Wanted: Bull Gear For Victor III

[Dave D]

HI all!
Wayne Holznagel asked me to repair his Victor III and I have discovered that his bull gear is severely worn. It is so bad that I don't feel comfortable just flipping the gear over. Can anyone help Wayne?

You can see that over half of the gear tooth is worn away. I could flip it over, but with that much wear, it does not seem like a good idea. What do you guys think?

IMG_8383.JPG (82 KiB) Viewed 255 times

IMG_8381.JPG (121.57 KiB) Viewed 255 times

IMG_8382.JPG (77.23 KiB) Viewed 255 times

Thanks!
Dave D

[Sidewinder]

Hi, what is a bull gear? Perhaps a picture could enliven the search?

[JerryVan]

Hi, what is a bull gear? Perhaps a picture could enliven the search?

A "bull" gear is a larger gear that drives a smaller one, while a pinion gear is a small gear that drives a larger one. Don't ask me why...

[JerryVan]

Dave,

You're correct, that gear is toast. I have to wonder about the condition of the worm. Are the sprirals still shiny & smooth, or are they scored and rough? Examination with a magnifying glass is sometimes needed to see the condition. A worn worm will drag down a motor and cause uneven speed.

[Dave D]

I figured that I had nothing to lose, so I flipped the gear and installed it with some rivets I made on the lathe.

IMG_8385.MOV

(13.9 MiB) Downloaded 42 times

[Phono-Phan]

Amazing job. It looks like it is running smooth.